I got my 3D printer a few days ago(The Micro 3D Printer, last night I sat down for 15 minutes and threw a super basic design together in Google sketchup. (I already had it installed…)
There’s two compartments in the underside, one for the LED ring+digispark, one for the battery+charger.
Not sure how I’ll do the bottom yet. Probably a thin sheet of plastic glued on.
I’ll print it in either white or clear pla, and apply some kind of coating to the top for water resistance.
First print was too small because sketchup messed up my measurements, but here’s some photos anyway:
New one is printing as I type!
And on that note, here’s some photos of the printer.
Note: I do find it prints better without a raft….